Bravada 2WD V8-5.3L VIN P (2004)
21. Place an adjustable jack stand under the lower control arm.
22. Using the adjustable jack stand raise the lower control arm and knuckle assembly in order to connect the upper ball joint to the upper control arm.
23. Install the upper ball joint pinch nut and bolt.
Tighten the nut to 40 Nm (30 ft. lbs.).
24. Remove the jack stand from under the lower control arm.
25. Connect the sway bar link pins to the lower control arm on both sides.
26. Install the steering gear.
27. Unsecure the propeller shaft from the frame.
28. Align the reference marks on the propeller shaft to the marks on the front axle pinion yoke.
29. Connect the propeller shaft to the front axle pinion yoke.
30. Install the yoke retainers and yoke retainer bolts to the front axle pinion yoke.
Tighten the bolts to 20 Nm (15 ft. lbs.).
31. Install the brake hose retaining bolts to the frame.
Tighten the bolts to 25 Nm (18 ft. lbs.).
