Bravada 4WD V8-5.3L VIN P (2004)
2. Lower the headliner in order to gain access to the wire harness.
3. Position the sunshade to the headliner.
4. Connect the sunshade electrical connector to the headliner harness.
5. Using a glue gun, hot melt the electrical connectors (1) to the headliner substrate, ensuring the connectors are securely attached to the substrate.
6. Route the wire harness until fully seated into the sunshade wire harness channel located on the pivot arm.
Important: If the wire harness retaining clip is removed from the sunshade for any reason, a new retaining clip must be installed.
7. Position the wire harness retaining clip between the headliner and the roof panel.
8. Position the index tabs on the wire harness retaining clip to the pivot arm and install the clip until fully seated.
With the wire harness retaining clip installed, the sunshade should remain attached to the headliner.
9. Position the inboard retainer (1) to the roof panel.
Notice: Refer to Fastener Notice in Service Precautions.
10. Install the inboard retaining screw.
Tighten the screw to 1.2 N.m (10 lb in).
