Bravada 4WD V8-5.3L VIN P (2004)
2. Disconnect the electrical connector from the defroster actuator.
3. Remove the screws from the defroster actuator.
4. Remove the defroster actuator.
INSTALLATION PROCEDURE
1. Install the defroster actuator.
2. Install the defroster actuator screws.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
3. Connect the electrical connector to the defroster actuator.
4. Install the IP carrier.
Mode Actuator Replacement
MODE ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the I/P carrier.