Bravada 4WD V8-5.3L VIN P (2004)
7. Clear a space on the ground about 1.85 m (6 ft) in diameter for deployment of the inflator module. If possible, use a paved, outdoor location free
of activity. Otherwise, use a space free of activity on the shop floor. Make sure you have sufficient ventilation.
IMPORTANT: Dual stage deployments are only used in the steering wheel and IP inflator modules, if the vehicle is equipped. If stage 1 was used to
deploy a dual stage inflator module, stage 2 may still be active. If disposal of a deployed or undeployed dual stage module is required, both
deployment loops must be energized to deploy the inflator module.
8. Make sure that loose or flammable objects are not in the area.
9. If you are deploying a steering wheel module, place the steering wheel module in the center of the space.
10. When deploying an P module, refer to the following instructions:
-
Place the J 39401-8 SIR deployment fixture (2) in the center of the cleared area.
-
Fill the deployment fixture with water or sand.
-
Mount the IP module (1) in the deployment fixture (2) with the vinyl/plastic trim facing up.
-
To mount, use 4 m 6 bolts (6), nuts (8), and washers (7) in order to properly secure the IP module (1) to the deployment mixture.
-
Securely tighten all fasteners prior to deployment.
