Bravada 4WD V8-5.3L VIN P (2004)
17. Measure the rotating torque of the pinion using an inch-pound torque wrench.
^
The rotating torque of the pinion should be 1.0 - 2.8 Nm (10 - 25 inch lbs.) for used bearings, or 1.7 - 3.4 Nm (15 - 30 inch lbs.) for new
bearings.
18. If the rotating torque measurement is below 1.0 Nm (10 inch lbs.) for used bearings, or 1.7 Nm (15 inch lbs.) for new bearings, continue to
tighten the pinion nut.
^
Tighten the pinion nut, in small increments, as needed, until the torque required in order to rotate the pinion is 1.0 - 2.8 Nm (10 - 25 inch lbs.)
for used bearings, or 1.7 - 3.4 Nm (15 - 30 inch lbs.) for new bearings.
19. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated.
Recheck the rotating torque and adjust if necessary.
20. Install the differential.
21. Install the brake rotors.
22. Install the brake calipers.
23. Install the tire and wheel assemblies.
24. Fill the axle with axle lubricant lubricant. Use the proper fluid.
25. Lower the vehicle.
