Bravada 4WD V8-5.3L VIN P (2004)
9. Disconnect the electrical connector from the window regulator.
10. Remove the regulator assembly from the end gate out the access hole.
Installation Procedure
1. Install the regulator assembly to the end gate through the access hole.
2. Connect the electrical connector to the window regulator.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the regulator side rails to the end gate by inserting the nuts (1) in the keyhole slots (2).
Tighten the regulator side rail nuts to 25 N.m (18 lb ft).
4. Install the bolt (3) retaining the regulator motor bracket to the end gate.
Tighten the regulator motor bracket bolt (3) to 10 N.m (89 lb in).