Bravada 4WD V8-5.3L VIN P (2004)
Rear Door Window Regulator: Service and Repair
Window Regulator Replacement - Rear Door (TrailBlazer, Envoy, Bravada)
Removal Procedure
1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the speaker.
4. Loosen the regulator window carrier bolts.
5. Raise and support the window.
6. Disconnect the electrical connector from the regulator motor.
7. Remove the 3 bolts that retain the window regulator assembly to the door.
8. Remove the window regulator assembly from the door.
Installation Procedure
1. Install the window regulator assembly to the door.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 3 bolts that retain the window regulator assembly to the door.
Tighten the bolts to 10 N.m (88 lb in).
3. Connect the electrical connector to the regulator motor.
4. Remove the window support and lower the window onto the regulator window carrier.
5. Loosely tighten the regulator window carrier bolts.
6. Operate the window upward to the full up position, ensuring the window remains in the run channels.
Tighten the regulator window carrier bolts to 10 N.m (88 lb in).
7. Install the speaker.
8. Install the water deflector.
9. Install the door trim panel.
