Calais L4-151 2.5L VIN U TBI (1989)
Backing Plate: Service and Repair
Hub and Bearing Assembly
REMOVAL
-
Raise car and suitably support.
NOTE: Mark relationship of wheel to hub and bearing assembly, to insure proper wheel balance upon reassembly.
-
Remove tire and wheel assembly.
CAUTION: Do not hammer on brake drum as damage to the bearing could result.
-
Remove brake drum. See: Brake Drum
CAUTION: The bolts which attach the hub and bearing assembly also support the brake assembly. When removing these bolts, support the brake
assembly with a wire or other means. Do not let the brake line support the brake assembly.
Hub And Bearing Assembly
NOTE: The top rear attaching bolt will not clear the brake shoe when removing the hub and bearing assembly. Partially remove hub and bearing
assembly prior to removing this bolt.
-
Remove hub and bearing assembly attaching bolts then remove assembly from axle.
INSTALLATION
-
Install hub and bearing assembly to rear axle.
-
Tighten hub and bearing bolts to 50 Nm (37 ft.lbs.).
-
Install brake drum. See:
-
Install wheel and tire assembly while noting alignment marks, then lower vehicle and torque wheel nuts to 140 Nm (100 ft. lbs.).