Calais V6-3300 3.3L MFI VIN N (1990)
NOTE: The clearance at the end of the caliper should be measured individually and added together to determine the total caliper to knuckle
clearance. The total clearance should be 0.26 - 0.60 mm (0.010 - 0.024 in.). If necessary remove caliper and file ends of bracket to provide proper
clearance.
Front Brake Hoses
5.
If brake hose inlet fitting was disconnected during removal, install and torque to 45 Nm (33 ft. lb.).
6.
Fill master cylinder. Bleed caliper if brake hose inlet fitting was disconnected and recheck master cylinder fluid level. See: Service and Repair
7.
After installation of calipers, perform clinching procedure as described below:
a. Firmly apply brake pedal three times to ensure caliper piston is extended and shoes are fully seated.
Clinching Procedure Step 1
b. Wedge a large flat blade screwdriver between outboard shoe flange and hat section of rotor. Pry up on outboard shoe.
c. Hold outer shoe against caliper with suitable clamp or by applying moderate pressure on brake pedal.
