Calais V6-3300 3.3L MFI VIN N (1990)
J28467
Support Fixture
J37087
Crankshaft Sensor Adjuster
J37096
Flywheel Holding Tool
Remove or Disconnect
1.
Negative Battery Cable
2.
Serpentine Belt Tensioner
3.
Inner Fender Splash Shield
4.
Torque Converter Cover
5.
Hold Flywheel with J37096
6.
Crankshaft Balancer Bolt
7.
Balancer
8.
Electrical Connections at Crank Sensor and Oil Pressure Sender
9.
Oil Pan Bolts and Oil Pan
10.
Front Cover Attaching Bolts and Cover
Inspect
-
Timing chain for overall "in and out" movement. Should not exceed 25.4 mm (one inch).
-
Sprockets for wear
Clean
-
Gasket mating surfaces at timing chain cover, and cylinder block.
-
If oil pan gasket is excessively swollen, the oil pan must be removed and the gasket replaced.
Install or Connect
1.
Front Cover Gasket
2.
Front Cover and Attaching Bolts
^
Apply Sealant GM P/N 1052080 or Equivalent to Bolt Threads
^
Tighten Bolts to 30 N-m (22 lbs.ft.)
3.
Oil Pan
^
Tighten Bolts to 10 N-m (88 lbs.in.)
4.
Electrical Connections
5.
Adjust Crank Sensor Using J37087 - See Section 6E3 for procedure
6.
Balancer and Bolt
^
Hold Flywheel with J37096
^
Tighten Bolt to 297 N-m (219 lbs.ft.)
7.
Torque Converter Cover
8.
Inner Fender Splash Shield
9.
Belt Tensioner
10.
Negative Battery Cable
WARRANTY INFORMATION:
Labor Operation Number:
J0780
Labor Time:
3.4 Hours
Trouble Code:
92
