Calais V6-3300 3.3L MFI VIN N (1990)
4.
Turn vehicle ignition off.
5.
Blower should come on after approximately 10 seconds for one second then go off.
6.
Disconnect jumper wire from pin H (green wire).
Add foam insulation as necessary to ensure rattle-free installation of the afterblow module under dash or in the front console area.
NOTE:
The afterblow module is not compatible with some non-factory installed theft alarm systems. The module current draw at key off
could trigger alarms that sensor battery voltage changes or current drain.
WARRANTY INFORMATION:
Labor Operation Number:
T6235 Labor Time:
Eighty-Eight, Ninety-Eight & Toronado
1.9 hrs.
Firenza & Cutlass Calais
1.7 hrs.
NOTE:
If it is necessary to clean debris from heater/evaporator case and seal the air inlet screen, please add 0.2 hr.
Trouble Code:
92