Calais V6-3300 3.3L MFI VIN N (1990)
Remove or Disconnect
1. Trim panel.
2. Water deflector.
3. Rear two rivets, upper and lower holding regulator to door panel using 1/4" drill bit.
4. Inside locking rod (12), inside handle to lock rod (13), lock cylinder to lock rod (5).
5. Three screws (10).
6. Lock (11).
7. Electrical connector (6).
Install or Connect
1. Electrical connector (6).
2. Lock(11).
3. Three screws (10).
NOTICE: It is required that while performing step 2 the lock assembly be held tight against door facing while installing screws. All screws must be
driven at a 90 degree angle to door facing to prevent cross threading or stripping of screws or door lock attaching holes. It is also required to tighten
screws to 7 N.m (62 lbs. in.). DO NOT OVER TIGHTEN.
4. Lock cylinder to lock rod (5), inside handle to lock rod (13), inside locking rod (12).
5. Two rivets holding regulator channel to door inner panel, using 1/4" peel type rivets.
6. Water deflector.
7. Trim panel.
Power Door Lock Actuator
