Calais FWD L4-151 2.5L (1985)
Figure 2
3. Remove the bumper retaining nuts (if not removed during transaxle mount removal).
4. Remove the bumper. Lift up on the inner mount assembly until the bumper can be removed. Refer to Figure 2.
5. Install the new bumper by lifting up on the inner mount assembly.
6. Install bumper retaining nuts.
7. Remove the mount from the vise.
8. Install the transaxle mount in the vehicle.
PARTS INFORMATION FOR CONDITION/CORRECTION 1:
Years
Model
Engine
Transaxle
Bumper P/N
1990-91
Cutlass Calais
2.5L
3T40 - Auto
22575851
1990-91
Cutlass Calais
2.5L
MT2 - Manual
22575852
1990-91
Cutlass Calais
3.3L
3T40 - Auto
22577698
CORRECTION FOR CONDITION 2: If this condition is encountered, replace both stabilizer shaft bushings with newer designed bushings. The part
numbers for the new bushings are listed below:
Stabilizer Shaft Diameter
Bushing Part Number(s)
22 mm
22566673
24 mm
22566674
26 mm
22566675
28 mm
22566676
30 mm
10088389
CORRECTION FOR CONDITION 3: Replace the tie rods with ones containing an improved bushing material using the procedure described in the
appropriate service manual. For effective repair use all parts in the kit, regardless of the original condition.
Part Number
Description
26032209
Left Side inner tie-rod assembly kit
26032210
Right Side inner tie-rod assembly kit
All parts mentioned in this bulletin are currently available from GMSPO.
