Calais FWD L4-151 2.5L (1985)
FIGURE 3 - CHECKING END PLAY MEASUREMENT
6.
Attach magnetic base (J-26900-13) to torque converter and set up dial indicator (J-8001) so that indicator tip is in center of tool wing nut. Refer to
Figure 3.
7.
To make end play check, push upper knurled knob down, zero out dial indicator and pull lower knurled knob up. Be sure tapered plug stays seated
in converter hub. End play is the difference between up and down positions. DO NOT ALLOW WING NUT TO TURN WHEN MEASURING.
8.
Remove tool by holding upper knurled knob and turning wing nut counterclockwise.
Refer to the following chart for torque converter end play specifications. Torque converters that exceed the maximum end play specifications should be
replaced.
Size
(Approximate
End Play
Style
Outside Diameter)
Specifications
Torque Converter
245 mm
0 - 0.50 mm
Clutch (T.C.C.)
(10 inches)
(0 - 0.019")
298 mm
0 - 0.60 mm
(12 inches)
(O - 0.023")
Open Converter
All Sizes
0 - 1.30 mm
(Non-T.C.C.)
(O - 0.050")
