oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Customer Interest: > < Fuel Pump - Objectionable Noise|Page 2950
Page 3
background image

FIGURE 4

12.

Raise and position fuel tank to vehicle underbody. Loosely attach straps to underbody placing two 7/16" flat washers, part number 3899696, or
equivalent on each of the strap bolts between strap and underbody attaching point (Figure 4).

FIGURE 5

13.

Insure fuel tank strap spacer located on L.H. strap is properly positioned under forward flange to tank (Figure 5). Torque L.H. strap bolt and then
R.H. bolt to 34 N-m (25 ft.lbs.).

14.

Inspect to insure forward tank flange is not contacting strap body bracket, and that sender pipes are not in contact with either tank or underbody.
Correct as required.

15.

Reconnect fuel hoses and electrical connector following service manual procedure, Section 6C.

16.

Start car, inspect for any fuel leakage and repair as necessary.

Parts that are required for this procedure, are available from GMSPO and are noted below excluding applicable pump and sender part numbers which
can be obtained from GMSPO parts catalog.

Part Number

Description

Quantity Reaquired

22530899

Sound Isolation Kit

1

25093965

Pulsator

1

3899696

7/16" Flat Washer or Equivalent

4

*22515965

Fuel Sender O-ring

1

*O-ring is included with fuel sender or pump service kit and separate ordering is not required when either of these components are replaced.

Labor Operation Number:

T5122

Labor Time:

1.1 hrs.

Customer Interest: > < Fuel Pump - Objectionable Noise|Page 2950