Ciera V6-173 2.8L VIN W FI (1986)
Steering Gear: Service and Repair
Removal and Installation
RACK AND PINION ASSEMBLY REMOVAL
TOOL REQUIRED
^
J 24319-01 Puller
Rack And Pinion Mounting
REMOVE OR DISCONNECT
1. Air cleaner.
2. Intermediate shaft lower pinch bolt.
3. Intermediate shaft from stub shaft.
CAUTION: Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear and/or
intermediate shaft. This damage can cause loss of steering control which could result in personal injury.
4. Line retaining clips.
5. Lines at gear from pump.
6. Raise car with suspension contact hoist.
7. Both front tire and wheel assemblies.
8. Tie rod ends from knuckles with J 24319-01.
9. Remaining brackets and clips on cross member.
10. Support body with stands to allow lowering of frame.
11. Rear frame mount bolts and lower rear of frame up to 128 mm (5").
NOTICE: Do not lower rear of frame too far as damage to engine components nearest to the cowl may result.
12. Heat shield (if equipped).
13. Rack and pinion mounting bolts.