Ciera V6-231 3.8L (1986)
PLASTIC TYPE
SYMBOL
Thermoset Urethane
RRIM
Thermoplastic Urethane
TPU
Thermosetting Polyester
UP (SMC)
Thermoplastic Urethane
RIM
Thermoplastic Elastomer
TPE
I.
GENERAL PAINT PROCEDURE FOR EXTERIOR FLEXIBLE PLASTICS
Polyvinylchloride (PVC), Polyurethane (PUR, TPUR, RRIM, RIM), Thermoplastic Elastomer (TPE), Thermoplastic Polyester (SMC), EPDM
Rubber (Supplied In Prime).
There are a multitude of finishing systems available on the market for painting and/or repairing flexible plastic parts. Following is a general
outline of painting procedures, including a list of available products. Refer to the manufacturer's literature available through your jobber for
details on proper mixing and application.
A.
Thoroughly clean part by washing with a suitable cleaning solvent* to remove all surface contaminates.
NOTICE:
Previously painted parts that show signs of cracking, peeling or improper adhesion must be stripped before repainting. The
old finish may be removed with any commercially available chlorinated solvent stripper or lacquer thinner.
NOTICE:
Do not soak parts longer than necessary to remove the old paint to avoid swelling.
B.
Scuff sand to an even dull appearance the entire surface to be painted with fine (400 grit or less) sandpaper and feather edge any
damaged areas and rewash as in Step A.
NOTICE:
Unpainted parts do not require sanding prior to painting, but should be thoroughly cleaned as in Step A.
C.
Apply two (2) thin coats of primer when required per top coat manufacturer's recommendation and allow to completely dry before
proceeding. (For most products, approximately 30 minutes).
D.
Prepare color coat according to the manufacturer's recommendation and apply sufficient double coats to develop the proper shade. For
best results, allow a few minutes flash time between each double coat and allow to completely dry before using.
E.
Following is a list of some of the products available for painting flexible plastic.
Ditzler Elastomeric Primer - DPX844 Ditzler Flexative - DX369 (Permanent Flexible Urethane Additive) Ditzler Flex Additive -
DX1798 (Non-Urethane Additive) Ditzler Delthane - DXR80 (Acrylic Enamel Hardener) Rinshed-Mason Acrylic Flex Agent 891
DuPont Dexlar Flexible Finish (Lucite tints plus Dexlar 365B Additive) Sherwin-Williams Flex Additive - V2V297 Acme/Rogers Flex
Additive - 699/4699 Martin-Senour Flex Additive - 3082
*Cleaning Solvents
1.
DuPont Prep-Sol
2.
Rinshed-Mason Pre-Kleano 900
3.
Ditzler Acryli-Clean DX330
4.
Sherwin-Williams R7K156
5.
Acme 88; Rogers 088
6.
Martin-Senour 6383
II. NYLON - Will be supplied in prime. Use the same procedure to refinish as on sheet metal parts.
III. ACRYLONNITRILE-BUTADIENE-STYRENE (ABS) - No prime required; paint with acrylic lacquer.
IV. POLYESTER PARTS (UP, PBTP) - Will be supplied in prime and/or black paint. Use the same procedure to refinish or repair as on sheet metal
parts.
V.
POLYPROPYLENE - Interior parts.
A.
Wash surface thoroughly with enamel reducer. (Do not use wax and grease removers.)
B.
Apply primer immediately and allow to dry completely before color coating.
C.
Color coat with lacquer or enamel reduced and applied according to the manufacturer's recommendation.
D.
Materials:
