Ciera Cruiser V6-173 2.8L VIN W FI (1986)
23.
Connect fuel lines at transaxle.
24.
Connect transaxle fluid fill tube at manifold.
25.
Connect wire harness at rear of RH head.
26.
Connect AIR hose at catalytic converter AIR pipe.
27.
Connect A/C compressor to brackets.
28.
Connect wires at A/C compressor and pressure cut-off switch.
29.
Connect P/S pump at engine.
30.
Install P/S belt and adjust.
31.
Connect heater hose at water pump.
32.
Install A/C belt and adjust.
33.
Install AIR pump pulley and belt.
34.
Install alternator belt and adjust.
35.
Install exhaust crossover.
36.
Install thermostat housing stud (to attach crossover).
37.
Connect necessary wires at engine (top).
38.
Connect necessary vacuum hoses.
39.
Connect brake booster vacuum hose.
40.
Connect grounds at thermostat housing.
41.
Connect heater hose at thermostat housing.
42.
Connect upper radiator hose.
43.
Refill cooling system using original coolant. Top off coolant level as required.
44.
Connect cruise cable and install bracket.
45.
Connect T.V. cable.
46.
Connect accelerator cable.
47.
Install air cleaner, battery and hood.
48.
Start engine and adjust timing and idle speed.
49.
Road test vehicle.
50.
Install Campaign Completion Label.
Label, Parts & Claim Information
CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label."
Each label provides a space to include the five digit dealer code of the dealer performing the campaign service. This information may be inserted with a
typewriter or ballpoint pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner.
