Custom Cruiser V8-307 5.0L (1987)
FIGURE 2
2.
Install the revised No. 3 mount as illustrated in Figure 2.
3.
Torque all bolts to 103 N-m (76 ft.lbs.).
4.
Repeat steps 1 through 3 for position No.3 mount on the other side of the frame.
PARTS REQUIRED:
Quantity
Part Number
2
25526705
2
25526703
2
25524280
2
14002113
2
14032535
Refer to the Labor Time Guide for warranty information.
Technical Service Bulletin # 87T16
Date: 870301
Frame/Body Mount - Creaking Noise
SUBJECT
NOISY FRAME MOUNTING
NUMBER: 87-T-16
DATE:
March 25, 1987
MODELS/YEARS
1987 NINETY-EIGHT MODELS WITH
SECTION: 2A
STANDARD SUSPENSION
Some 1987 Ninety-Eight models may develop a noise at the rear frame to body mounting area. The noise can originate on either side of the vehicle and
is caused by the position No. 3 frame to body insulator. The noise sounds like a creak in the door area and occurs on start and stop movement of the
vehicle.
To correct the condition, both No. 3 insulator assemblies must be replaced (even if the noise only came from one side) as follows:
