oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

All Technical Service Bulletins for PROM - Programmable Read Only Memory:|92T68A > < PROM - Powertrain Control Module Reprogramming
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
PROM - New Calibration Reduces Chuggle

NUMBER: 92-T-176

CORP.REF.NO: 376507

DATE: July 1993

SECTION: 6E2, V6 7A, 4L60

SUBJECT:
CHUGGLE - NEW CALIBRATION PROM

MODELS/YEARS:
1992 CUSTOM CRUISER W/5.7L (VIN 7) ENGINE AND 2.73 AXLE (RPO GU2)

CONDITION:
Some owners with vehicles listed below, equipped with 5.7L V8 engines, may comment about a "chuggle" condition.

This bulletin addresses the following vehicle/condition ONLY:

Vehicle

Condition

Custom Cruiser

Chuggle with base axle only

RPO GU2, 2.73 ratio

CAUSE:
Insufficient dampening of the torque converter and PROM calibration.

CORRECTION:
New calibration PROMs have been released to address the above vehicle/condition.

The PROM is NOT RECOMMENDED for vehicles with OPTIONAL 3.23 AXLE RATIOS or TRAILER TOWING PACKAGES.

Note:
The above vehicles produced before December 16, 1991 (Julian Date 350) may have HydraMatic 4L60 Model 2DDM Transmissions. Model 2DDM
transmissions may contain torque converters with insufficient dampening.

Vehicles with Model 2DDM transmission - Check dealer records to see if the torque converter has already been replaced with P/N 8650935 (tagged
Broadcast Code: DGAF). It is not necessary to replace those torque converters with P/N 8650935.

Transmissions with torque converters with P/N 8656959 (tagged B/C: DG5F) need to have the torque converter replaced with P/N 8650935.

Model 2BRM transmissions P/N 8650935 (produced after December 16, 1991) have the new torque converter.

Parts are currently available from GMSPO.

WARRANTY INFORMATION:
Labor Operation
Replace PROM

T0500

0.6 hour

Replace Torque Converter

K7020

2.8 hours

All Technical Service Bulletins for PROM - Programmable Read Only Memory:|92T68A > < PROM - Powertrain Control Module Reprogramming