Cutlass L4-138 2.3L VIN A FI HP (1990)
26. Electrical connector to ignition coil and module assembly.
27. Negative battery cable.
28. Start engine and inspect for oil leaks. Add oil, if required.
NOTE: If new lifters have been installed or the lifters bled down while engine was disassembled, excessive lifter noise may be experienced. This
is a normal condition, no engine damage is occurring. Use the following procedure to purge the air from the lifters:
-
Start engine and allow to warm up at idle for 5 minutes.
-
Increase engine speed to 2000 rpm until the lifter noise is gone.
-
Return engine to idle for an additional 5 minutes or road test.