Cutlass L4-138 2.3L VIN A FI HP (1990)
Engine Rear Mount
Rear Mount
1.
Disconnect battery ground cable.
2.
Using engine support No. J-28467 or equivalent, relieve engine weight from rear mount.
3.
Raise and support vehicle, then remove right hand lower splash shield.
4.
Remove rear engine mount through bolt and nut, then remove four bracket to body attaching bolts, Fig. 2.
5.
Remove bracket assembly and mount from vehicle, then remove three mount to bracket attaching nuts and separate mount from bracket.
6.
Reverse procedure to install.
