Cutlass L4-138 2.3L VIN A FI HP (1990)
3.
Mark a location on the centerline 150.O mm (5-7/8") forward of the large retainer plate hole in the spare tire cover (See Illustration).
4.
Remove the cover from the vehicle, locate and mark a spot 35 mm (1-3/8") to the right of the previous mark at 150 mm (See Illustration).
5.
Using a 20 mm (3/4") hole saw, drill a hole at the mark to the right of the centerline.
6.
Using a sharp utility knife, cut a 9 mm (11/32") by 10 mm (13/32") long slot toward the centerline of vehicle and install the new jack handle
retaining bolt, P/N 10165650 in the hole.
7.
Lay the tire cover face down on a clean work surface, and position the new jack handle, P/N 10158395 on the retaining bolt.
8.
Cut two 25 mm (1") pieces of the edge insulating material from the cover, locate under each end of the handle (to act as anti-rattle pads), and glue
into place using trim adhesive.
9.
While the adhesive is drying, remove the spare tire, remove and discard the old ratchet handle, socket and retaining clip and bolts.
10.
Reinstall the spare tire in the rear compartment.
11.
Install and tighten the nut, P/N 10165652 to retain the jack handle to the spare tire cover.
12.
Reinstall the tire cover in the rear compartment. Locate and install the new jacking label, P/N 10165653 directly on top of the old one.
13.
Reinstall and position the rear compartment floor covering.
WARRANTY INFORMATION:
Labor Operation Number:T1600
Labor Time:
0.4 Hour
Trouble Code:
92
