Cutlass L4-138 2.3L VIN A FI HP (1990)
Crankshaft Position Sensor: Service and Repair
Crankshaft Sensor IDI
REMOVAL
1.
Disconnect negative battery cable.
2.
Disconnect electrical connector from the crankshaft sensor.
3.
Remove sensor hold-down bolt.
4.
Remove sensor from engine.
5.
Inspect the crankshaft sensor o-ring for cracks, wear or leakage. Before installing new sensor, lubricate the new o-ring with engine oil.
INSTALLATION
1.
Insert the new sensor into the hole in the engine block.
2.
Tighten the sensor hold-down bolt and torque to 88 lb. in. (10 N-m).
3.
Connect crankshaft sensor electrical connection to the wiring harness.
4.
Reconnect negative battery cable.