Automatic Transmission/Transaxle Component Information for 1990 Cutlass
Figure 1 - Previous And New 4TH Clutch Plate Assembly
BULLETIN SECTION COVERS: (Figure 1)
A new two plate 4th clutch assembly (501) and apply plate (502) are used to replace the single plate 4th clutch assembly for some 1990
HYDRA-MATIC 4T60 (THM 440-T4) transaxles. The extra plate was added for higher torque engine applications. For this change to be implemented,
the following parts were modified:
-
4th clutch plates assembly (fiber) are thinner by 0.51 mm (0.020"). The fiber material is the same thickness; only the steel part of the plate was
made thinner. The two plate assembly has four white stripes, while the single plate fiber plate has four green stripes.
-
4th clutch reaction plates are made thinner by 0.1 mm (0.004") for the two plate assembly.