Cutlass L4-138 2.3L VIN A FI HP (1990)
Transmission Mount: Service and Repair
Transaxle Mount
TRANSAXLE MOUNT 3T40 (125C) AUTOMATIC TRANSAXLE
Transaxle Mounts
REMOVE OR DISCONNECT
1. Raise and suitably support vehicle.
2. Support transaxle with jackstand.
3. Bolts attaching bracket to transaxle.
4. Nuts attaching bracket to mount.
5. Bracket. Refer to "Transaxle Bracket".
6. Bolts/nuts attaching mount support to frame.
7. Mount support.
8. Nuts attaching mount to support.
INSTALL OR CONNECT
1. Mount and attaching nuts to support.
TIGHTEN
^
Nuts to 48 Nm (35 lb. ft.).
2. Support and attaching bolts/nuts to frame.
3. Bracket and attaching nuts to mount.
4. Bracket to transaxle bolts.
5. Remove jackstand
6. Lower vehicle.
