Cutlass L4-138 2.3L VIN A FI HP (1990)
3. Transaxle oil cooler lines at transaxle.
4. Bolts holding engine wiring harness to transaxle case.
5. Raise left side of frame and install new frame to body bolts.
6. Nuts attaching bracket to mount.
TIGHTEN
^
Nuts to 48 Nm (35 lb. ft.).
CAUTION: When installing the intermediate shaft make sure the shaft is seated prior to pinch bolt installation. If the pinch bolt is inserted
into the coupling before shaft Installation, the two mating shafts may disengage.
7. Pinch bolt at intermediate steering shaft.
8. Splash shield.
9. Tire and wheel assembly.
10. Lower vehicle.
11. Left-hand torque strut bracket to power steering bracket.
TIGHTEN
^
Stud to top of transaxle bracket to 54 Nm (40 lb. ft.).
12. Remove J 28467-A and J 36462.
13. Negative battery cable.
14. Air cleaner.
