Cutlass L4-138 2.3L VIN A FI HP (1990)
Transaxle Bracket - 2.3L Engine/Hydra-Matic 3T40
TOOLS REQUIRED:
^
J 28467-A Engine Support Fixture
^
J 36462 Engine Support Adapter Leg
REMOVE OR DISCONNECT
1. Air cleaner.
2. Negative battery cable.
3. Install J 28467-A and J 36462.
4. Left-hand torque strut bracket from power steering pump.
5. Raise vehicle and suitably support.
6. Left front tire and wheel.
7. Left lower engine splash shield.
CAUTION: Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear and/or
intermediate shaft. This damage may cause lass of steering control which could result in personal injury.
8. Pinch bolt at intermediate steering shaft.
9. Support right and left sides of frame with jackstands.
10. Nuts attaching bracket to mount.
11. Left frame to body bolts.
12. Adjust jackstand to lower left side of frame.
13. Bolts holding engine wiring harness to transaxle case.
14. Transaxle oil cooler lines at transaxle.
15. Bolts attaching bracket to transaxle.
16. Bracket.
INSTALL OR CONNECT
1. Bracket.
2. Bolts attaching bracket to transaxle.
TIGHTEN
^
Rear bolt to 83 Nm (61 lb. ft.).
^
Front bolts to 48 Nm (35 lb. ft.).
3. Transaxle oil cooler lines at transaxle.
4. Bolts holding engine wiring harness to transaxle case.
5. Raise left side of frame and install new frame to body bolts.
6. Nuts attaching bracket to mount.
