Cutlass L4-138 2.3L VIN A FI HP (1990)
Power Switch Assembly Removal
REMOVE OR DISCONNECT
1. Switch plate assembly from armrest trim panel by prying up with flat bladed tool.
2. Retainers from connectors.
3. Connectors from switch plate assembly.
4. Cable from bezel assembly by loosening set screw, if equipped.
INSTALL OR CONNECT
1. Cable to bezel assembly, if equipped. Tighten set screw to secure.
2. Connectors to switch plate assembly.
3. Retainers to connectors.
4. Switch plate assembly to armrest trim panel pressing firmly to engage component clips.
Rear Door
POWER WINDOW AND DOOR SWITCH ASSEMBLY - SEDAN REAR DOOR
NOTICE: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of
shorting out the switch if a screwdriver, awl or metal object is used to remove the switch from the harness.
