Cutlass L4-138 2.3L VIN A FI HP (1990)
INSTALL OR CONNECT
1. Regulator through access hole.
2. Electrical connector to motor (power window system).
3. Rivets using 1/4 inch x 1/2 inch peel type rivets.
4. Nuts
TIGHTEN
Nuts to 9 Nm (80 lb. in.).
5. Water deflector.
6. Door trim panel.
Coupe And Sedan Front Doors
NUMBER:
91-T-60
CORP.REF.NO: 831075
DATE:
February 1991
SECTION:
10
SUBJECT:
SERVICE MANUAL UPDATE - FRONT DOOR WINDOW REGULATOR MOTORS, REVISED SERVICE PROCEDURE
MODELS/YEARS:
1988-91 CUTLASS SUPREME
This bulletin cancels and supercedes Dealer Technical Bulletin 89-T-23. Please discard Dealer Technical Bulletin 89-T-23.
This bulletin describes a revised procedure to replace electric window lift motors from front window regulator mechanisms in 1988-91 Cutlass Supreme
models. Please mark a reference to this bulletin in the following Cutlass Supreme Service Manuals:
YEAR
PAGE
1988
10-5W-17
1989
10-5-16
1990
10-5-33
1991
10-6-41
1.
Remove regulator assembly from door.
CAUTION:
STEP 2 MUST BE PERFORMED WHEN REGULATOR IS REMOVED FROM DOOR, THE REGULATOR LIFT ARM IS UNDER TENSION
FROM THE COUNTERBALANCE SPRING AND CAN CAUSE PERSONAL INJURY IF THE MOTOR IS REMOVED WITHOUT LOCKING
THE SECTOR GEAR IN POSITION.
