Cutlass V6-191 3.1L VIN M SFI (1998)
slightly smaller or larger than the original. This same condition can also occur when printing the template from SI2000. Before proceeding, verify
that the copy made is the same size as the original by measuring the width (a) and length (b) of the template. The width (a) should be 24 mm (15/16
in) and the length (b) should be 66 mm (2-5/8 in).
3.
Make a photocopy of the template shown above.
4.
Place the template copy over the lock cylinder bezel and align the "EDGE" on the template (2) with the edge of the face of the instrument panel
compartment door (1).
Important:
The position of the centerline of the hole on the top of the instrument panel compartment door should be approximately 1.6 mm (1/16 in) forward of
the edge of the face of the instrument panel compartment door and in-line with the key slot in the lock cylinder.
5.
Fold the template to the contour of the instrument panel door. Mark the position of the center line of the small hole on the template to the
instrument panel compartment door.
6.
Remove the template.
Important:
The rearward edge of the drilled hole should be flush with the edge of the face of the instrument panel compartment door.
7.
While lifting up on the instrument panel compartment door (1) handle, drill a 3.2 mm (1/8 in) hole at the point (2) marked in Step 5.
8.
Insert the key into the instrument panel compartment door lock cylinder.
9.
While lifting up on the instrument panel compartment door handle, insert a 1/16 in. hex head wrench, or the equivalent, into the drilled hole and
depress the lock cylinder retainer.
The lock cylinder retainer is spring loaded and is part of the lock cylinder.
10.
Turn the key clockwise to the 3 o'clock position.
11.
Using the key to side load the cylinder, remove the lock cylinder from the instrument panel compartment door.
