Cutlass V6-191 3.1L VIN M SFI (1998)
Keyless Entry Receiver: Service and Repair
Remote Keyless Entry Module Programming
Module Mounting And Wiring (Typical)
A Remote Control Door Lock Receiver can have up to four different transmitters programmed to it. A transmitter can be programmed to more than one
vehicle providing the remote keyless entry systems are similar. When reprogramming one transmitter, any and all other transmitters (maximum of four
(4) total per receiver) must be reprogrammed at the same time in order for the other transmitters to work.
IMPORTANT
^
Leave a window down in the vehicle while reprogramming the Remote Control Door Lock Receiver system. This will avoid unintentional lock out
if the reprogramming procedure is not properly performed.
1. Turn Ignition off.
2. Ground the receiver program terminal by jumping the two terminals located in the program ground connector.
^
Within 2 seconds the door locks will Lock, Unlock and Rear Compartment Lid Release will cycle and horn chirp will sound to indicate module is
ready to be reprogrammed.
3. Press and hold the LOCK and UNLOCK buttons at the same time until the door locks Lock and Unlock, the Rear Compartment Lid Release
releases and the horn chirp sounds to indicate the transmitter has successfully been reprogrammed. (Approximately 12 seconds).
4. Repeat Step 3 for the remaining transmitters.
5. Remove the jumper at the program connector.
6. Verify proper operation of each transmitter.
