Cutlass V6-191 3.1L VIN M SFI (1998)
2. Connect the brake pipes from the wheel cylinders to the Hydraulic Modulator.
-
Tighten the tube nuts to 24 Nm (18 ft. lbs.).
3. Connect the brake pipes from the master cylinder to the proportioning valve.
-
Tighten the tube nuts to 24 Nm (18 ft. lbs.).
4. Connect the Brake Motor Pack electrical connector.
5. Connect the two brake solenoid valve electrical connectors.
6. Install the upper radiator hose.
7. Install the Battery tray.
8. Install the Battery to Vehicle.
IMPORTANT: Bleed the system.
9. Perform the Diagnostic System Check.
Brake Modulator Bracket Replacement
