Cutlass V6-191 3.1L VIN M SFI (1998)
18.
Adjust the stop lamp switch and cruise release switch.
18.1. Pull the brake pedal (4) upward against the internal pedal stop.
18.2. Turn the switch 90 degrees clockwise in order to lock the switch into position.
19.
Install the accelerator control cable to the pedal lever assembly. Ensure the tangs are fully expanded and seated.
20.
Slip the accelerator control cable through the slot in the rod of the accelerator pedal and install the retainer in the rod. Ensure the retainer is seated.
21.
Check for proper operation of stop lamps and cruise control.
22.
Install the left sound insulator panel.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty use the table.
DISCLAIMER
