Cutlass V6-191 3.1L VIN M SFI (1998)
Evaporative Emission Control Canister: Service and Repair
Removal Procedure
1. Raise the vehicle.
2. Disconnect the hoses from the EVAP canister (2).
3. Disconnect the EVAP canister retainer attaching bolt (1).
4. Remove the EVAP canister and the retainer.
Installation Procedure
1. Install the rearward end of the EVAP canister retainer into the slot in the EVAP bracket (rotate the EVAP canister to insert the top of the EVAP
canister under the tab).
2. Install the EVAP canister retainer attaching bolt (1).
Tighten
^
Tighten the EVAP canister retainer attaching bolt to 10 Nm (88 lb in).
Important: When installing the EVAP canister, the canister vent hose must be routed below the fuel tank fill and vent hoses.
3. Connect the hoses to the canister.