Cutlass V6-191 3.1L VIN M SFI (1998)
Throttle Cable/Linkage: Service and Repair
Accelerator Cable Bracket Replacement
REMOVAL PROCEDURE
1. Remove the accelerator cable cross slug from throttle body slot.
2. Depress the tangs and remove the accelerator cable from accelerator cable bracket.
3. Remove the nuts and bolts holding the accelerator cable bracket to the throttle body.
4. Remove the accelerator cable bracket.
INSTALLATION PROCEDURE
1. Install the accelerator cable bracket to throttle body.
2. Install the nuts and bolts.
^
Tighten the nuts to 26 N.m (19 lb. ft).
^
Tighten the bolts to 12 N.m (106 lb in).
3. Install the accelerator cable into accelerator cable bracket.
4. Install the accelerator cable cross slug into throttle body slots.
