Cutlass V6-191 3.1L VIN M SFI (1998)
Failure to dispose of an inflator module as instructed may be a violation of federal, state, province, or local laws.
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to follow
the procedures in the order listed may result in personal injury.
Deploy the inflatable restraint steering wheel inflator module outside of the vehicle when the vehicle will be returned to service. Situations that require
deployment outside of the vehicle include the following:
^
Using the SIR diagnostics, you determine that the inflator module does not function properly.
^
The inflator module is scratched or ripped on the cover.
^
The inflator module pigtail (if equipped) is damaged.
^
The inflator module connector is damaged.
^
An inflator module connector terminal is damaged.
Deployment and disposal of a malfunctioning inflator module is subject to any required retention period.
1. Turn the ignition switch to the OFF position.
2. Remove the ignition key.
3. Put on safety glasses.
4. Inspect the J 38826 and the appropriate pigtail adapter for damage. Replace as needed.
5. Short the two SIR deployment harness (1) leads together using one banana plug seated into the other.
6. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
7. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module in Steering Column Steering Wheels.
8. Remove the horn lead from the back of the module, if equipped.
9. Remove the redundant steering wheel control leads from the back of the module, if equipped.
10. Remove all horn/steering wheel control buttons from the module, if equipped.
CAUTION: When you are carrying an undeployed inflator module:
^
Do not carry the inflator module by the wires or connector on the inflator module
^
Make sure the bag opening points away from you
When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module
rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free
space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.
11. Place the module with the vinyl trim cover facing up and away from the surface on a work bench.
