Cutlass V6-191 3.1L VIN M SFI (1998)
8. Install the engine strut to (1) the crossmember (5).
9. Install the stabilizer bar (1) to the crossmember (6).
Tighten
-
Tighten the stabilizer shaft-to-support-assembly bolts to 66 N.m (49 lb ft).
10. Install the splash shield to the crossmember.
11. Install the brake lines to the retainers on the cross member.
12. Install the right and left wiring harnesses to the crossmember.
13. Slightly raise the vehicle. Remove the jack stands from under the crossmember.
14. Install the tire and wheel assembly. Refer to Wheel Installation.