Cutlass V6-191 3.1L VIN M SFI (1998)
6. Remove the components from the strut (7):
-
Cap (1)
-
Strut mount nut (2)
-
Strut mount bearing (3)
-
Upper spring insulator (4)
-
Strut dust shield (9)
-
Jounce Bumper (8)
-
Strut coil spring (5)
-
Lower spring insulator (6)
INSTALLATION PROCEDURE
Notice: Care should be taken to avoid scratching or cracking the spring coating when handling the front suspension coil spring. Damage can cause
premature failure.
1. Install the bearing cap if it had been previously removed.
2. Mount the strut into the J 34013-B using the bottom locking pin only.
3. Extend dampener shaft and install the J 34013-20 on the dampener shaft.
4. Install the spring over the dampener.