Cutlass V6-191 3.1L VIN M SFI (1998)
Washer Fluid Level Indicator: Service and Repair
Washer Solvent Level Sensor Replacement
REMOVE OR DISCONNECT
1. Raise vehicle.
2. Left splash shield from vehicle.
3. Air intake duct from vehicle.
4. Connector (4) from washer solvent level sensor (5).
IMPORTANT
^
Washer solvent will drain from container when sensor is removed. Place a suitable drain pan under container before removing sensor.
5. Solvent level sensor (5) and seal (9) from washer solvent container assembly (7).
INSTALL OR CONNECT
1. Seal (9) in washer solvent container assembly (7).
2. Solvent level sensor (5) in solvent container assembly (7).
3. Connector (4) to solvent level sensor (5).
4. Air intake duct to vehicle.
5. Left splash shield to vehicle.
6. Lower vehicle.
7. Fill washer solvent container assembly (7) with washer solvent.
