Cutlass V6-260 4.3L DSL (1984)
STEP NO. 3
From inside the vehicle, cut a 9 mm (11/32") hole though the filler panel trim using the location hole as a guide.
NOTE:
When a raised speaker grille is used, cut a 14 mm (9/16") hole for the sleeve. Ref. View C of Section A-A. Fig. 3.
STEP NO. 4
Remove the trim material from around the hole and push the insulation under the trim away from the hole.
Top Strap Procedure
FIGURE 4 - TOP STRAP ANCHOR ASSEMBLY INSTALLED - CUTLASS CIERA WAGON (TWO SEAT)
STEP #1
Mark the appropriate drilling point on the floor, RH or LH side wall carpet and cut a 9 mm (11/32") hole through the carpet and insulation
STEP #2
Center punch a drill point as marked in Step 1 and drill a 9 mm (11/32") hole through the sheetmetal.
NOTE:
The floor pan hole should be located to the right of the drain hole.
Childseat Information
This information is a supplement to Dealer Technical Bulletin 84-T-3 issued December 19, 1983. The general instructions for installation of the child
seat top strap are covered in the original bulletin. The Figures listed below cover the specific instructions for the following body styles:
