Cutlass V8-307 5.0L VIN 9 4-bbl HP (1984)
997782
"J" Firenza 13 x 5" Wheel
997783
"J" Firenza 13 x 5-1/2" Wheel w/F41
When the vehicle is being made ready for delivery, the lock brackets are to be installed prior to installation of the wire wheel cover and medallions.
1.
Raise vehicle with lift equipment.
2.
Remove three (3) lug nuts from each wheel for lock bracket installation - refer to illustration. Figure 1.
3.
Place lock bracket on lug nut studs.
4.
Install three (3) special lug nuts on each wheel to retain lock bracket and torque to specifications. LOOSE CONDITION OF LOCK BRACKET
WILL BE NORMAL. WHEN LUG NUTS ARE SEATED, FRONT WHEEL STUDS WILL HAVE A RECESSED APPEARANCE, WHICH IS
NORMAL.
5.
Install wheel cover on wheel.
6.
Tighten lock bolt with lock key wrench.
7.
Snap in center medallion.
8.
Install removal label to underside of deck lid next to jacking instruction label.
9.
The lock key wrench is to be placed in the glove box along with the I.D./Registration Card.
FIGURE 2
The procedure for removal and installation is to be explained to the owner prior to delivery.
