Cutlass Ciera L4-2.2L VIN 4 (1995)
8.
Secure the two pivot plates using the four black rivets supplied in the kit.
9.
Reinstall headliner and trim lace.
For warranty purposes use:
Labor Operation
Labor Time
T6429
0.6 hr
Location of Sunshade, Air Deflector, Shield.
Isolation of Sunshade, Air Deflector, Shield
To isolate components and eliminate rattles in the rest of the sunroof assembly, complete all of the following steps on 1988 and 1989 vehicles. Add loop
material (soft loop half of hook-and-loop fastener system, such as Velcro or Scotchmate Hook and Loop Fastener, 3M P/N 06480) in the following
locations as required:
1.
Remove sunshade. Open glass panel part way.
2.
Add loop material (40 mm long) at the front of the glass panel on the underside. Refer to Figure 4 for locations. This prevents air deflector rattles
against the bottom of the glass panel.
3.
Add a small pad (10 mm) of loop material at the top front corners of the track. Locate pad so deflector rests on it when closed.
4.
Add loop material, approximately 70 mm long, on the top (back side) of the sunshade in the area of the reinforcement. Refer to Figure 5 for
locations.
5.
Add one piece of loop material at the rear of the sunshade, approximately 50 mm long, wrapped around the edge at the center.
6.
Reinstall sunshade.
