Cutlass Ciera L4-2.2L VIN 4 (1995)
Fig. 7 Shoe Spreading To Install Adjuster Actuator
INSTALLATION
1. Lubricate raised shoe pads on backing plate, anchor surfaces on backing plate, and adjuster screw threads using brake lubricant No. 1052196 or
equivalent.
2. Install retractor spring if removed by hooking center spring section under tab on anchor.
3. Install park shoe and lining assembly as follows:
a. Place shoe on backing plate.
b. Using special brake tool J 38400 or equivalent, pull end of retractor spring up to rest on web of brake shoe, Fig. 5.
c. Using special brake tool J 38400 or equivalent, pull end of retractor spring over until if locks into slot of brake shoe, Fig. 6.
4. Install park brake lever.
5. Install adjuster screw and adjuster shoe as follows:
a. Place shoe on backing plate.
b. Using special brake tool J 38400 or equivalent, pull end of retractor spring up to rest on web of brake shoe.
c. Using special brake tool J 38400 or equivalent, pull end of retractor spring over until if locks into slot of brake shoe.
6. Install adjuster actuator by spreading shoes using special brake tool J 38400 or equivalent, Fig. 6. Then install adjuster actuator.
7. Install actuator spring.
8. Adjust brakes using suitable adjustment tool. Lining diameter should be 0.050 inches less than inside diameter of each drum.
9. Install drums, wheels and tires, aligning marks made during removal.
