Cutlass Ciera V6-3100 3.1L VIN M SFI (1996)
Case: Service and Repair
CASE SIDE COVER AND GASKETS
Case Side Cover, Pump And Valve Body
TOOLS REQUIRED:
^
J 28467-A Engine Support Fixture
^
J 36462 Engine Support Adapter Leg
REMOVE OR DISCONNECT
1. Air cleaner and resonator.
2. Install J 28467-A, and J 36462.
3. Torque struts at engine mounts.
4. Shift control cable from transaxle.
5. Shift control cable bracket and position aside.
6. Raise vehicle and suitably support.
7. Left front tire and wheel.
8. Left lower ball joint.
9. Left inner fender splash shield.
CAUTION: Failure to disconnect the intermediate shalt from the rack and pinion stub shaft can result In damage to the steering gear and/or
Intermediate shaft. This damage may cause loss of steering control which could result in personal injury.
10. Pinch bolt at intermediate steering shaft.
11. Exhaust pipe from manifold.
12. Support right and left sides of frame with jackstands.
13. Transaxle mount and mount support.
14. Left frame to body bolts, and adjust jack stand to lower left side of frame.
15. Right frame to body bolts.
16. Jack stands.
17. Steering shaft from steering gear stub shaft.
18. Left drive axle.
19. Position drain pan under transaxle.
20. Case side cover pan and gasket.
