Cutlass Ciera V6-3300 3.3L (1990)
Rear Door Interior Handle: By Symptom
Technical Service Bulletin # 90T94105
Date: 900401
Inside Door Handle to Lock Rod, Front - Disengaged
SUBJECT
INSIDE HANDLE TO DOOR LOCK RODS ON FRONT
DOORS, DISENGAGED FROM LOCK (NEW PARTS AND PROCEDURE)
MODELS/YEARS
1990 CUTLASS CIERA AND CUTLASS CRUISER
MODELS
NUMBER:
90-T-94
CORP.REF.NO: 031007
DATE:
April 1990
SECTION:
10-5
Some early 1990 Cutlass Clera and Cutlass Cruiser models may exhibit an inside handle to lock rod that becomes disengaged at the lock end during
operation. This condition may be due to a rod with an incorrect bend length at the lock end.
If the condition is present, it may be corrected by using the following parts and procedures:
Inside Handle To Lock Rods:
Coupes Right - 10177206 Left - 10177207
Wagons and Sedans
Right - 10160496
Left - 10160497
Parts are currently available from GMSPO.
Procedure:
1.
Remove trim panel and water deflector.
2.
Using a 3/16" drill bit, drill out the inside handle attaching rivet and remove handle.
3.
Rotate clip on lock end of rod to disengage, remove rod and discard.
4.
Install rod into clip on lock lever and rotate clip to retain rod.
5.
Install inside handle on forward end of rod, position handle properly on inner panel and fasten using a 3/16" rivet.
6.
Operate all lock rods to insure proper operation.
7.
Reinstall water deflector and door trim panel.
WARRANTY INFORMATION:
Use existing labor operation and time allowance.
Technical Service Bulletin # 90T94105
Date: 900401
Inside Door Handle to Lock Rod, Front - Disengaged
SUBJECT
INSIDE HANDLE TO DOOR LOCK RODS ON FRONT
DOORS, DISENGAGED FROM LOCK (NEW PARTS AND PROCEDURE)
MODELS/YEARS
1990 CUTLASS CIERA AND CUTLASS CRUISER
MODELS
NUMBER:
90-T-94
CORP.REF.NO: 031007
DATE:
April 1990
SECTION:
10-5
