Cutlass Ciera Cruiser V6-3100 3.1L MFI VIN M (1994)
NOTICE:
Access for the sealer application to front edge can be done through the front opening of the door to fender with door in full open position.
Apply material on an acid brush, and paddle sealing material into position.
9.
Install new relay to connector.
10.
Reposition and tape relay to harness with connector pointing down as shown in Figure 3.
NOTICE:
DO NOT install new relay in original position.
11.
Reinstall carpet, right side shroud finishing panel molding and sound insulator panel molding and sound insulator panel.
12.
Reconnect battery cable and reset radio presets.
13.
Install a Campaign Identification Label.
Campaign Identification Label
Each label provides space to print the campaign number and the five (5) digit retailer code of the retailer performing the campaign. Insert this
information with a typewriter or ball-point pen. When installing label, clean and dry the surface of the radiator support tie bar and apply the campaign
label where it is readily visible.
Each Campaign Identification Label is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner.
Warranty Claim Information
