Cutlass Ciera Cruiser V6-3100 3.1L MFI VIN M (1994)
Knock Sensor: Service and Repair
Knock Sensor Assembly
REMOVE OR DISCONNECT
1. Disconnect negative battery cable
2. Raise vehicle
3. Disconnect knock sensor wiring harness connector
4. Remove knock sensor from vehicle
INSTALL OR CONNECT
1. Install knock sensor into engine block, ensure threads are clean and do not over tighten.
Tighten
Knock Sensor to 19 Nm (14 lb. ft.)
2. Connect electrical connector to sensor
3. Lower vehicle
4. Connect negative battery cable
