Cutlass Ciera Cruiser V6-3100 3.1L MFI VIN M (1994)
Coolant Temperature Sensor/Switch (For Computer): Description and Operation
Engine Coolant Temperature Sensor
PURPOSE
The Engine Coolant Temperature (ECT) sensor is a thermistor (a resistor which changes value based on temperature) mounted in the engine
coolant stream. Low coolant temperature produces a high resistance (100,000 ohms at -40° C (-40° F) while high temperature causes low
resistance (70 ohms at 130° C (266° F).
OPERATION
The Powertrain Control Module (PCM) supplies a 5 volt signal to the ECT sensor through a resistor in the PCM and measures the voltage. The
voltage will be high when the engine is cold, and low when the engine is hot. By measuring the voltage, the PCM calculates the engine coolant
temperature. Engine coolant temperature affects most systems the PCM controls.
The Tech 1 displays engine coolant temperature in degrees. After engine start-up, the temperature should rise steadily to about 90°C (194°F) then
stabilize when thermostat opens. If the engine has not been run for several hours (overnight), the engine coolant temperature and intake air
temperature displays should be close to each other. A fault in the engine coolant sensor circuit should set Diagnostic Trouble Code (DTC) P0117
or DTC P0118. The DTC charts also contain a table to check for sensor resistance values relative to temperature. See: Testing and Inspection
