Cutlass Ciera Cruiser V6-3100 3.1L MFI VIN M (1994)
Brake Switch - TCC: Service and Repair
Brake Switch
REMOVE OR DISCONNECT
1. Drivers side hush panel.
2. Electrical connector(s).
2. Switch assembly.
Inspect
Switch retainer for cracks.
INSTALL OR CONNECT
1. New switch assembly into retainer.
A. Hold brake pedal depressed while installing switch or valve. Switch should bottom on retainer. Note that audible clicks can be heard as the
threaded portion of the switch is pushed through the retainer.
B. Slowly pull brake pedal fully rearward against pedal stop moving switch or valve assembly rearward.
C. Release brake pedal and pull back again to assure proper adjustment of switch or valve.
D. Visually reinspect retainer for cracks.
2. Electrical connector(s).
3. Driver's side hush panel.
